To restore and space of drywall that has been broken you will need sheet rock, a utility knife, quick dry-low mud joint compound, mesh tape for drywall, one inch galvanized drywall screws, a drill, drywall knife and a drywall sanding block. Use an digital stud finder to mark the studs behind the broken drywall, then use a drywall saw or reciprocating noticed to chop away the drywall. Use a utility knife to scrap away the drywall until the screw is uncovered. Drywall harm can vary from small cracks to large holes, but most repairs are straightforward and inexpensive to fix.
For the sort of repair, you first need to wash out the outlet with a blade knife, angling your minimize to make the entrance of the opening larger than the back. If tape is simply unfastened on one aspect can slip a putty knife beneath it to loosen, then slip tape and joint compound beneath whole piece of free tape, then press hard to wall.
Widths, an inside-nook knife, a utility knife, a hammer, a screwdriver, a drywall noticed and a drill. Smoothing out the perimeters of the drywall compound flush with the surface of the wall known as feathering. Use drywall screws to connect the drywall to the cleats (picture three) and to any studs between them, as in new construction.
Next, use a wide (eight- to 12-inch) joint-compound taping knife to utterly cowl the patch with a third and final coat. Merely adhere the patch to the wall and canopy with drywall compound. Once the second coat is dry, clean it out with another light hand sand, dust the floor clear and you’re ready for portray.
Let the patch dry and apply a second coat of compound if needed. Can cowl with mud or not or use spackle. Gently sand floor until clean with the wall. After it dries, sand frivolously, wipe away mud and repaint the entire space. Outer drywall corners are reinforced with metal or plastic edging, called corner bead.